顶棚内饰板转弯处弧度小，无法与文件柜有效搭接。左下裙板搭接处结构复杂，

The curvature of the ceiling trim panel is small and cannot be effectively overlapped with the filing cabinet. <br>The overlapping structure of the lower left skirt board is complicated, and the reason for the gap is basically caused by the cumulative tolerance of the parts. <br>1. The back of the right side baffle of the storage box lacks support, and the baffle is recessed inward. <br>2. Deformation of components: the plastic baffle is deformed, and the gap between the inward depression and the floor skin is large. <br>The skeleton clamping point of the co-pilot at the instrument panel is low, and the <br>protective strength at the branch of the wiring harness with a large gap between the instrument panel after clamping is insufficient <br>. Water leaks when spraying. <br>The profile light and the harness are not lit after they are inserted into place. The light is turned on when the harness is pushed hard, and it goes out when you let go. The preliminary analysis is that the lamp is not in proper contact with the harness terminal. <br>When the door control switch is sub-assembled, all four mounting holes are not snapped into the nut. The impact force of the pneumatic tool is strong, resulting in deformation of the nut seat.

The roof interior panel has a small arc at the turn and cannot be properly connected to the filing cabinet.<br>The structure of the lower left apron is complex, causing the gap to be caused by the cumulative tolerance of the components.<br>1, the storage box right side of the back of the bezel lack of support, bezel inward depression.<br>2, parts deformation: plastic bezel deformation, to the inward depression and floor skin gap large.<br>The skeleton card connection at the vice-driver of the instrument station is low, and the gap between the gauge table body is large after the card is secured.<br>Insufficient protection at the harness branch, lack of protection at the harness terminals<br>Wiper arm spray water pipe insertion position tension is insufficient, after insertion loose, spray water leakage.<br>The profile light and the harness are not lit when plugged into the position, push the rear light of the harness to light, and turn off after loosening your hand. The preliminary analysis indicates that the contact between the lamp and the harness terminal is not true.<br>The door control switch was not divided into the nut all four mounting holes, the pneumatic tool impact force is strong, resulting in the nut seat deformation.

The turning part of the ceiling interior trim panel has a small radian and cannot be effectively overlapped with the filing cabinet.<br>The structure of the lap joint of the left lower apron is complex, and the gap is basically caused by the accumulated tolerance of the parts.<br>1. The back of the baffle on the right side of the storage box lacks support and the baffle is sunken inward.<br>2. Deformation of parts: the plastic baffle is deformed, and the gap between the inward depression and the floor skin is large.<br>The frame of the front passenger's seat of the instrument panel is on the low side, and the gap between the frame and the instrument panel body is large after being clamped<br>The protection strength at the branch of harness is insufficient, and the harness terminal is lack of protection<br>The tightening force of the spray water pipe of the wiper arm is insufficient. It is loose after plugging, and water leaks during spraying.<br>After the clearance lamp and harness are inserted in place, they do not light up. Push the harness hard and the lamp will light up, and then it will go out. The preliminary analysis shows that the contact between the lamp and the harness terminal is not true.<br>When the door control switch is assembled separately, the four mounting holes are not all clamped into the nuts. The impact force of the pneumatic tools is strong, resulting in the deformation of the nut seat.<br>