特别提示1.离心机在安装或闲置期间，为防止轴承承载点应力锈蚀，请每半月

Special Note <br><br>1. centrifuge during installation or idle, in order to prevent stress corrosion point bearing carrier, please each pair of half main bearing two refueling, 2 minutes or start running hand plate 20 movable drum rotation. <br>2. The stop must be switched off before the feed pump or feed valve. After the shutdown will not allow the feed or water. Preventing liquid into the bearing cause bearing damage. <br>3. Each end of the work, the machine must be cleaned and may not exist in the product material drum. Before cleaning the end of the shutdown, turn off the pump or into the inlet valve. <br>4. Cleaning method: the engine speed to 1500 rev / min or more, running into the water for 2-3 minutes, stop. Repeatedly washed several times, until the outlet water is more clear. <br>Note: Clean water not too large (feed tube not appear water phenomenon) <br>5. centrifuge assembly and disassembly is prohibited direct hit with a hammer. Prohibit the use of high-temperature treatment centrifuge welding, gas cutting and other parts.

Special tips<br><br>1. During installation or idle operation, in order to prevent the pressure rust of bearing bearing point, please refuel the two main bearings every half a month, start running for 2 minutes or move the drum by hand 20 turns.<br>2. The feed pump or feed valve must be closed before stopping. Never allow inding or water after shutdown. Prevents fluid from flowing into the bearings, causing bearing damage.<br>3. At the end of each work, the machine must be cleaned and must not contain material in the drum. Before cleaning is complete, close the inlet water pump or inlet valve before closing.<br>4. Cleaning method: machine speed to 1500 rpm or more, into the water operation 2-3 minutes, stop. Wash it repeatedly several times until the outlet is clear.<br> Note: The amount of cleaning water must not be too large (the feeding tube must not appear the phenomenon of running water)<br>5. When removing the centrifuge, it is forbidden to hit directly with a hammer. It is prohibited to process parts of centrifuges at high temperatures such as electric welding and gas cutting.

hot tip<br>1. During the installation or idle period of the centrifuge, in order to prevent the stress corrosion at the bearing bearing point, please oil the two main bearings every half a month, start the centrifuge for 2 minutes or turn the drum by hand for 20 revolutions.<br>2. The feed pump or feed valve must be closed before shutdown. Never allow feed or water to enter after shutdown. Prevent fluid from entering the bearing and damaging the bearing.<br>3. At the end of each work, the machine must be cleaned and there shall be no accumulated material in the drum. Close the water inlet pump or water inlet valve before shutdown after cleaning.<br>4. Cleaning method: turn the machine speed to more than 1500 rpm, run the machine with clean water for 2-3 minutes, and stop the machine. Wash repeatedly until the outlet water is clear.<br>Note: the cleaning water volume shall not be too large (there shall be no flowing water in the feed pipe)<br>5. When installing and disassembling the centrifuge, it is forbidden to hit directly with a hammer. It is prohibited to use electric welding, gas cutting and other high-temperature treatment of centrifuge parts.