本设备是铝合金铝屑熔化专用设备，适用于铝合金屑的连续快速熔化。熔炉后部

This device is a scrap aluminum alloy melting equipment, for continuous rapid melting of aluminum scrap. The furnace is provided with a rear side of the vortex well and the molten pool of molten aluminum pump rotor, liquid latent heat of aluminum rapid melting aluminum scrap, aluminum scrap burning combustion. Other side of the furnace discharge flow cell. Holding chamber combustor burner using light inflammation, mainly to achieve rapid heating of molten aluminum, high heating efficiency, the burner regulator uses a continuous proportional control mode, at any level so no combustion, the oxygen content in the furnace atmosphere is maintained at a substantially a lower level, effective control of the generation of oxides in the furnace, to further reduce the oxidation loss. Using a special lining materials, but also to present the melting furnace life can be greatly extended, this melting furnace using the formulation to add special slag resistance of refractory bricks and castables, under normal operating conditions, the overall service life of the lining is greater than three years.

This equipment is a special equipment for aluminum alloy chip melting, suitable for the continuous rapid melting of aluminum alloy chips. The rear of the furnace is equipped with a side melting pool with a whirlpool well and an aluminum liquid rotor pump, which uses aluminum liquid latent heat to quickly melt the aluminum chips and burn the aluminum chips to burn. A water flow tank is set on the other side of the furnace. The maintenance chamber burner uses the bright burner, mainly to achieve the rapid heating of aluminum liquid, high heating efficiency, the regulation of the burner adopts a continuous proportional adjustment method, so no reason to burn at high and low, the atmosphere oxygen content in the furnace is basically maintained at a low level, effectively control the generation of oxides in the furnace, further reduce oxidation burn. The use of special furnace lining materials, but also make the life of the melting furnace can be greatly extended, the melting furnace using the addition of special anti-slag formula pouring material and refractory brick, in the normal operating conditions, the overall service life of the furnace lining is greater than three years.

This equipment is a special equipment for melting aluminum alloy chips. It is suitable for continuous and rapid melting of aluminum alloy chips. The back of the furnace is equipped with a side melting pool with a vortex well and an aluminum rotor pump, which uses the latent heat of aluminum to melt the aluminum chips quickly and burn the aluminum chips. The other side of the furnace is provided with a drain chute. The burners in the holding chamber are bright burners, which are mainly used to raise the temperature of aluminum liquid rapidly, with high heating efficiency. The burners are adjusted in a continuous proportion way. Therefore, when there is no control over high and low combustion, the oxygen content in the atmosphere in the furnace is basically kept at a low level, which effectively controls the generation of oxide in the furnace and further reduces the oxidation and burning loss. The use of special lining materials also greatly extends the service life of the furnace. The furnace adopts castables and firebricks with special slag resistant formula. Under normal operation, the overall service life of the furnace lining is more than three years.