machine: FLM500wheel: cast iron gro

machine: FLM500
wheel: cast iron grooved.
pressure plate: cast iron. grooved only for part A.
dressing ring: cast iron full.
holding carriers: item 4806, item 4807 for part B and C.
carriers: 0.5mm 7 holes for part C first side diameter 47.5mm.
slurry: part A SIC 500.
part B and C diamond MSY 4-6 PTG/RS

Part A:
SIC 500 with S-oil. 30 part in the carrier. only with pressure plate. speed
level 5, running 4 minutes, flipping parts and every second parts change
position 180 degrees. running again 4 minutes. stock removal about 0.028mm

Part B:
MSY 4-6 PTG-RS, holding carrier item 4806, D22mm.
Fixing the parts: holding carrier on marble stone and put a 0.03mm foil
below to get a distance between.
Put the brasse lardon and fix the part with the M6 screw. Not tighten too
much.
Cycle time about 6 minutes, speed level 5, no additional pressure. stock
removal about 0.015mm

Part C:
MSY 4-6 PTG/RS
first side (D47.5mm), 6 parts into the 2mm thickness and 7 holes carriers.
Running 6 to 10 minutes with speed level 5.
Second side with holding carrier, item 4807, D20 mm. Fix 8 parts same a
written under part B. Running 4 to 6 minutes with speed level 5.
stock removal about 0.01 mm in 4 minutes.