图3所示的污泥最终含水率，在0.25MPa下，含水率的下降时由于添加了

The final moisture content of the sludge in FIG. 3, in 0.25MPa, when the water content decreased due to the addition of additives results in a different, and for a single additive which increases with water content decreased pressure has fallen to about 2 ~ 3%, which is due to the increased pressure, not because of the use of different additives, is not considered to be in decline after adding the additives had on the moisture content of additives and nothing to do, but and stress-related, then the article said the moisture content of 9% decline is not a reason not all additives are added?

Figure 3 shows the final moisture content of the sludge, under 0.25MPa, the water content of the decline due to the addition of different additives, and for a single additive, its water content decreased with the increase of pressure, about 2 to 3%, this is due to the increase in pressure, not because of the use of different additives, Can it be thought that after the addition of additives, the decline in moisture content is not related to additives, but related to pressure, then the article said that the water content of 9% of the decline is not all the reasonfor for adding additives?

The final water content of sludge as shown in Figure 3 is caused by the addition of different additives when the water content decreases at 0.25MPa, while for a single additive, the water content decreases by about 2-3% with the increase of pressure. This is because of the increase of pressure, not because of the use of different additives. Can we think that the water content after the addition of additives The decrease of the water content is not related to the additives, but to the pressure. Is the 9% decrease of the water content mentioned in the article not all the reasons for the additives?