先用蜂鸣器上的夹子夹其中的红金绿色线(各一根),再用蜂鸣器的另一头感应

First use the clip on the buzzer to clamp the red, gold and green wires (one for each), and then use the other end of the buzzer to sense, and use the jig to cut the foot 40±2mm from the bottom. There is no need to cut the feet if the three wires are connected to the feet, and the three wires previously clamped with the clamps are also measured from the bottom to cut the feet 40±1m

First with the buzzer clip one of the red and gold green line (one each), and then with the other end of the buzzer sensing, the ringing of the wire with a fixture from the bottom to cut feet 40±2mm, not loud without cutting feet, three lines to the foot after completion, the previous clip clamped three lines also measured from the bottom of the cutting feet 40±1m.

First use the clip on the buzzer to clip the red, gold and green lines (one for each), and then use the other end of the buzzer to sense. Measure the ringing wire from the bottom with a fixture to cut the leg by 40 ± 2mm. If it does not sound, do not cut the leg. After the three wires pair the feet, measure the three wires previously clamped with the clamp from the bottom to cut the feet by 40 ± 1m<br>