3月6日质检科、总装和设计在线对副驾驶中下面板员与地板皮间隙大问题进行

March 6 quality control section, assembly and design of online panel members and the co-pilot in the lower floor a big problem skin was measured gap analysis. 1, shown in FIG. 2 there are two points where a gap problem (inspectors currently required quality threshold of two issues mentioned points are recorded separately) FIG gap offset spacer site analysis skin floor corner position, 3, FIG. 4, resulting in insufficient corner support gap. FIG 2 is temporarily recording gap design, where the need for space charge of design for digital to analog matching, seized by the outer dimensions of the floor for skin check measurements.

On March 6th, the quality inspection department, assembly and design online carried out a measurement and analysis of the large problem of the mid-to-lower panel man and the floor leather gap of the co-pilot. As shown in Figure 1, Figure 2, there are two gap points in the problem here, (the quality door inspector is currently required to separate the two problem points recorded) Figure 1 gap site analysis for the floor leather corner pad position offset, as shown in Figure 3, Figure 4, resulting in insufficient support at the corner, resulting in gaps. Figure 2 gap temporarily record the design, the competent design of this gap for digital mode check, the external inspection section of the floor leather dimension situding measurement.

On March 6, the quality inspection department, the general assembly department and the design department online measured and analyzed the large gap between the bottom board member and the floor skin of the copilot. As shown in Fig. 1 and Fig. 2, there are two gap points in this problem. (at present, the quality gate inspector has been required to record the two problem points separately.) the gap in Fig. 1 is analyzed on site as the location deviation of cushion block at the turning of floor leather, as shown in Fig. 3 and Fig. 4, resulting in insufficient support at the turning and gap. Fig. 2 the gap is temporarily recorded for design, which needs to be checked by digital analog by the supervisor design, and the dimension check and measurement by the external inspection department.