柱模板采用九合板，在柱钢筋、预留孔，预埋件预埋完毕并经验收后，才能立模

The column formwork adopts nine plywood. The formwork can be erected after the column reinforcement, reserved holes, pre-embedded parts have been pre-embedded and received experience. The formwork is externally equipped with 60×80 square wood, and temporary supports are set, and then made of Ф12 round steel. After correcting the verticality and flatness of the tension bolts, tighten the nut, and finally fix the column mold with pile hoop. The distance between the column hoop is not more than 600mm, and finally tighten with steel pipe and cross fasteners. The support rod is connected with the support frame of the floor slab to improve its integrity.

Column template using heptation plate, in the column rebar, reserved holes, pre-buried parts and experience, can stand the template, template external equipment 60 × 80 square wood, and then set up temporary support, and then interspersed with 12 Round steel made of pull bolts, correct verticality and flatness, tighten the nut, and finally in the column mold plus pile hoop fixed, column hoop spacing is not greater than 600mm, and finally the use of steel pipe and cross fastener tension. The support bar is connected with the support frame of the floor to improve its integrity.

The column formwork is made of nine plywood. After the column reinforcement, reserved holes and embedded parts are embedded and received, the formwork can be erected. The external equipment of the formwork is 60 × 80 square timber, and then the temporary support is set. Then the split bolts made of Ф 12 round steel are interposed. After the verticality and flatness are corrected, the screw caps are tightened. Finally, the column formwork is fixed with pile hoops, and the spacing between the column hoops is not more than 600mm. Finally, the steel pipe and ten steel pipes are used Tighten the fasteners. The supporting rod is connected with the supporting frame of the floor to improve its integrity.<br>