轴2上零件的组装顺序是从左到右，剥皮辊的左端是轴承，齿轮6是齿轮3是齿

The assembly sequence of the parts on the shaft 2 is from left to right, the left end of the peeling roller is the bearing, the gear 6 is the gear 3 is the gear 2, and the right end is equipped with a peeling device and the bearing end cover. damage. According to the gearbox manual, the diameter of the wheel hole must be greater than 20. Since a stepped shaft is selected, the length of the tenon is 32, 35, and 40. Since the length of the tenon is 40, the part is the longest, so you only need to check this position. The design of the shaft is shown in the parts drawing.

The assembly order of the parts on shaft 2 is from left to right, the left end of the peeling roller is the bearing, gear 6 is gear 3 is gear 2, the right end is equipped with peeling device, bearing end cover. damage. According to the transmission manual, the diameter of the wheel hole must be greater than 20. Because the step shaft is selected, the length of the pals is 32, 35, and 40. Because the length of the slug is the longest part of 40, you only need to check this position. The design of the shaft is displayed in the part diagram.

The assembly sequence of parts on shaft 2 is from left to right. The left end of peeling roller is bearing, gear 6 is gear, and gear 3 is gear 2. The right end is equipped with peeling device and bearing end cover. Damage. According to the transmission manual, the diameter of the wheel hole must be greater than 20. The length of tenon is 32, 35 and 40 due to the selection of stepped shaft. Since the part with tenon length of 40 is the longest, you only need to check this position. The design of the shaft is shown in the part drawing.<br>