锁紧后，开启开关，前翻转盖板单侧打不开，偶尔有双侧同时打不开，锁止拉丝

After locking, the switch is turned on, the front cover flipped open unilateral, bilateral simultaneous occasionally open, drawing off the lock, stroke length, and the vehicle body latch fixed point to be adjusted (to adjust the actual amount of restructuring no modification) , circlip skewed latch, the effective stroke smaller opening and closing the switch. (The following analysis is preliminary rectification, a design change after the problem persists, the need to re-project analysis)

After locking, open the switch, the front flip cover one side can not open, occasionally there are two sides at the same time can not open, lock pull wire off, long stroke, lock and body fixed point need to adjust (the actual no adjustment amount of modification deformation), lock snap reed skewed, open and close switch effective travel is small. (The following analysis is for pre-correction, after the design changes, the problem still exists, need to re-establish the analysis)

After locking, open the switch. The front flip cover plate can't be opened on one side, and sometimes it can't be opened on both sides at the same time. The locking wire falls off, the travel is long, the fixed point between the lock and the body needs to be adjusted (there is no actual adjustment amount to change the deformation), the lock circlip is skewed, and the effective travel of the switch is small. (the following analysis is the preliminary rectification, and the problems still exist after the design change, which needs to be analyzed again)<br>