8、 找正完毕，需要拧紧全部气缸和曲轴箱连接螺栓，在气缸与曲轴箱结合面

8. After the alignment is completed, you need to tighten all the cylinders and crankcase connecting bolts, re-drill the positioning pin holes at the joint surface of the cylinder and the crankcase, drill one on each side of the cylinder in the length direction, the width direction drive end and the non-drive end Drill 1 each, 8 in total. For the diameter and depth of the positioning pin hole, please refer to the size of the old positioning pin to match the drill. <br>9. After the cylinder reversing adjustment is completed, please refer to the requirements of the manual to disassemble the compressor and clean it before reassembling.

8, find the right finish, need to tighten all cylinders and crankcase connection bolts, in the cylinder and crankcase combination surface position re-drill positioning pin hole, all levels of cylinder length direction on both sides of each drill 1, width direction drive end and non-drive end each drill 1, a total of 8, positioning pin hole diameter and depth please refer to the size of the old anchor pin diamond.<br>9, after the cylinder change adjustment is completed, please refer to the requirements of the instruction manual, the compressor disintegrated clean and reassembled.

8. After alignment, all connecting bolts of cylinder and crankcase shall be tightened, and locating pin holes shall be re drilled at the joint surface of cylinder and crankcase. One shall be drilled on both sides of cylinder length direction at all levels, and one for drive end and non drive end in width direction, 8 in total. Please refer to the size of old locating pin for diameter and depth of locating pin.<br>9. After the cylinder reversing adjustment is completed, please refer to the requirements of the manual, disassemble and clean the compressor, and then reassemble it.<br>