1、零部件三坐标检测合格，拟定整改方案后，R&D反馈零部件与数模存在差

1. The three coordinate tests of the left and right corners of the instrument are qualified. After the rectification plan is drafted, there are differences between the design feedback parts and the digital model. <br>2. After physical improvement, there will be a problem of unmatched design digital model, and the design department agrees to change the state. <br>3. The fixed points of the corner plates are at the three red dots in the figure, and there are no fixed points at the ends.

1, the instrument left, right corner plate alone three coordinates test qualified, after the formulation of rectification program design feedback components and digital mode there are differences.<br>2, after physical improvement of the design of digital modules will have unmatchable problems, the design department agreed to change the state.<br>3, the angle plate fixed point in the three red dots shown, there is no fixed point at the end.

1. The left and right corner plates of the instrument are qualified through independent three-dimensional inspection, and there are differences between the design feedback parts and the digital analog after the rectification plan is proposed.<br>2. After the improvement of the physical object, there will be problems that cannot be matched on the design digital analog, and the design department agrees to change the state.<br>3. The corner plate fixing point is at the three red points shown in the figure, and there is no fixing point at the end.