4、机器的调整 试运转正常后，然后方可上粮试验。上粮时应保证喂入量由小

4. Adjustment of the machine After the <br>trial operation is normal, the grain test can only be carried out. When feeding grain, ensure that the feeding amount is gradually increased from small to large, and there is no grain shortage. Observe the distribution of the crops on the surface. If the movement direction of the whole grain is not in the correct position of the grain outlet, adjust the screw on both sides of the rear wheel. The movement direction of the material is correct.

4, the adjustment of the machine.<br> After the test runs normally, the food test can be carried out. When feeding food should ensure that the feeding amount from small gradually to large, and there is no food break phenomenon, look at the distribution of surface crops, if the whole grain material movement direction is not in the correct position of the grain ratio, then by adjusting the rear wheel wire rod on both sides to achieve the correct movement direction of the material.

4. Adjustment of the machine<br>After the test run is normal, the grain can be loaded for test. During grain loading, the feeding amount should be gradually increased from small to large, and there is no grain shortage. Observe the distribution of crops on the belt surface. If the movement direction of the whole grain is not in the correct position at the grain outlet, the movement direction of the material can be realized by adjusting the rear wheel screw rods on both sides.<br>