雨刮盖板支架的尺寸与雨刮盖板的安装孔位置不匹配，支架是科新的，盖板是清

Mounting hole locations do not match the size of the wiper cover wiper cover stent, the stent is about new cover plate is Fook-River, the spacing is less than the effective spacing of the clip bracket mounting holes of the cover plate, resulting in shedding the stent . <br>Staff did not clean up after the excess standard cab assembly caused by debris and waste <br>staff during assembly tools and door knocking cause scratches <br>connection tubes smaller, the smaller the angle, the assembly process is easy to discount <br>barcode printing is not completed, the lack of provisions in part, failed bar code field to be replaced, the test control batches embodiment late incoming <br>frame harness early due to a temporary two-dimensional code figure number identifies the figure number more than two, causing the system does not recognize, the system has been improved post. <br>1, employees during assembly tools and scratches caused by foot bump <br>2, the process of packing and transport process scratch bump caused "

The size of the wiper cover bracket does not match the installation hole position of the wiper cover plate, the bracket is new, the cover is Qinghe Futong, the spacing of the bracket card is less than the effective spacing of the cover mounting hole, resulting in the bracket easy to fall off.<br>Employees do not clean up excess standard parts after assembly resulting in cab debris and waste<br>Scratch caused by tool and door bumps during employee assembly<br>Connection tube bundle is fine, angle is small, easy to discount during assembly<br>Bar code printing is not completed, the lack of provisions part, on-site non-conforming bar code replacement, late-in-stock implementation batch inspection control<br>Frame harness two pre-period due to the temporary map number of the two-dimensional code identification of two bits, resulting in the system can not be recognized, the system has been improved later.<br>1, the staff assembly process tools and foot bumps caused scratches 2, the sub-assembly process and the transfer process bump caused scratches.

The size of the wiper cover support does not match the location of the wiper cover installation hole. The support is scientific and new. The cover plate is Futong Qinghe. The spacing between the clamps of the support is less than the effective spacing of the cover plate installation hole, which causes the support to fall off easily.<br>Cab clutter and waste caused by staff not cleaning excess standard parts after assembly<br>Scratches caused by collision between tools and doors during staff assembly<br>Connecting bundle is thin, angle is small, and easy to discount in assembly process.<br>Bar code printing is incomplete, lack of provisions, on-site replacement of unqualified barcodes, and batch inspection control of late purchase.<br>In the early stage of frame harness II, because of the two-dimensional code identification of temporary figure number, the system can not be recognized, and the system has been improved in the later stage.<br>1. Scratches caused by collision between tool and foot in the assembly process of employees<br>2. Scratches caused by collisions during loading and transshipment“<br>