使用说明使用须知1、使用水壶前请清洗干净（杯内可水洗）。2、只能使用指

Instructions for <br><br><br><br>use <br>1. Please clean the kettle before using it (the cup can be washed with water). <br>2. Only use the designated power supply, such as 12V or 24V, and cannot be mixed. <br>3. Before boiling water, please add water to the electric kettle, and the water level should not be higher than the bottom of the cup, so as not to overfill. <br>4. Insert the power plug firmly into the cigarette lighter socket, and the red indicator light will turn on to start heating. After the water is boiled, the indicator light goes out, and the heat preservation state is entered, and the water temperature is lower than 85 degrees and the heating is automatically turned on. <br>5. During the driving of the car, due to rugged roads or braking, etc., you must pay attention to safety when using this product to prevent burns. <br><br><br>Three guarantees <br>The three guarantees period of this product is calculated from the date of purchase. Replacement within 15 days, repair within 60 days, excluding personal factors. <br><br>The lid of this product is equipped with a vent hole. It is strictly forbidden to block the vent hole. If the vent hole is blocked, the company will not be responsible. <br><br>, No heating <br>when plugged in ; 2. Power <br>failure occurs within a few minutes after plugging in the power ; <br>3. Overheating of the cigarette lighter plug; <br>4. Buzzing sound when plugging in the power. <br> <br>2. Replace the original car’s current-limiting cigarette lighter socket <br>2. Change to the power supply as shown on the right <br>3. Cut off the cigarette lighter plug and connect directly to the <br>battery (recommended)

Instructions for use<br><br>What to know about use<br>1, before using the kettle please clean (cup can be washed).<br>2, can only use the specified power supply, such as 12V or 24V, can not be mixed use.<br>3, before boiling water, please add water to the electric kettle, the water level must not be higher than the bottom cup mouth, so as not to be too full.<br>4, the power plug firmly inserted into the cigarette lighter socket, the red light light began to heat. After the water boils, the light goes out, enters the insulation state, and the water temperature is below 85 degrees and the heating is automatically turned on.<br>5, the car driving process, due to the existence of rough roads or brakes and other reasons, so the use of this product must pay attention to safety, to prevent burns.<br><br>Three-pack guarantee<br>The three-pack period is calculated from the date of purchase of this product. 15 days to change, 60 days to repair, except for personal factors.<br><br>The lid of this product is equipped with air-out holes, it is strictly prohibited to block the air-out holes, such as clogging out of the pores and any situation, the Company is not responsible.<br><br>, plug in the power supply does not heat;<br>2, plug in the power for a few minutes to appear<br> Power outages;<br>3, the cigarette-pointing plug overheating;<br>4, plug in the power beep.<br> <br>, replace the original car with a limited flow point cigarette socket<br>2, press the right illustration to change the power supply<br>3, cut off the cigarette dot plug directly connected<br> Battery (recommended)

instructions<br>Instructions for use<br>1. Please clean the kettle before use (the cup can be washed).<br>2. Only use the specified power supply, such as 12V or 24V, not mixed.<br>3. Before boiling water, please add water into the electric kettle. The water level should not be higher than the bottom cup mouth to avoid overfilling.<br>4. Insert the power plug firmly into the cigarette lighter socket, and the red indicator light will be on to start heating. After the water boils, the indicator light goes out and enters the heat preservation state. When the water temperature is lower than 85 ℃, the heating will be started automatically.<br>5. In the process of driving, due to the uneven road surface or braking and other reasons, so the use of this product must pay attention to safety, in order to prevent scalding.<br>Three Guarantees<br>The warranty period of this product is calculated from the date of purchase. Replacement within 15 days, repair within 60 days, except for personal factors.<br>The lid of this product is equipped with air outlet. It is strictly forbidden to block the air outlet. Our company will not be responsible for any situation caused by blocking the air outlet.<br>Plug in the power supply without heating;<br>2. It will appear in a few minutes after the power is plugged in<br>Power failure;<br>3. The cigarette lighter plug is overheated;<br>4. A beep appears when the power is plugged in.<br>Replace the socket of the current limiting cigarette lighter<br>2. Connect the power supply according to the right figure<br>3. Cut off the cigarette lighter plug and connect it directly<br>Battery (recommended)<br>