3月6日质检科、GA矫鹏和在R&D张亚军线对副驾驶中下面板与地板皮间隙

March 6, quality control section, GA correction Peng and copilot of the lower floor panel and a big issue clearance skin were measured and analyzed in the R & D Zhang Yajun line. 1, shown in FIG. 2 there are two points where a gap problem (inspectors currently required quality threshold of two issues mentioned points are recorded separately) FIG gap offset spacer site analysis skin floor corner position, 3, FIG. 4, resulting in insufficient corner support gap. Figure 2 outside issues preliminary measurements seized by the co-pilot qualified carpet size, the gap temporarily recorded in the design, to be in charge of the design of the space here to check for digital to analog, the outer skin to the floor seized by a detailed check size measurement.

On March 6th, the Quality Inspection Department, GA Zhang Peng and the runner-up line in the R-D Zhang were surveyed and analyzed the large problem of the mid-to-lower panel and floor skin gap of the co-pilot. As shown in Figure 1, Figure 2, there are two gap points in the problem here, (the quality door inspector is currently required to separate the two problem points recorded) Figure 1 gap site analysis for the floor leather corner pad position offset, as shown in Figure 3, Figure 4, resulting in insufficient support at the corner, resulting in gaps. Figure 2 The external inspection section of the problem preliminary measurement of the co-pilot carpet size qualified, gap temporary record design, the competent design of this gap for digital mode check, the external inspection section of the floor leather size for detailed check-check measurement.

On March 6, the quality inspection department, GA Jiao Peng and Zhang Yajun line of R & D measured and analyzed the large gap between the lower panel and the floor of the copilot. As shown in Fig. 1 and Fig. 2, there are two gap points in this problem. (at present, the quality gate inspector has been required to record the two problem points separately.) the gap in Fig. 1 is analyzed on site as the location deviation of cushion block at the turning of floor leather, as shown in Fig. 3 and Fig. 4, resulting in insufficient support at the turning and gap. Fig. 2 the dimension of the assistant driver's carpet is qualified after preliminary measurement by the external inspection department. The gap is temporarily recorded and designed. It needs to be checked by the supervisor's design through digital analog, and the external inspection department conducts detailed verification and measurement of the floor skin dimension.