仪表台骨架卡扣固定点位置偏低，卡固后与仪表台本体间隙大线束分叉处防护强

Low dashboard skeleton snap-fastening position, the latching instrument panel body with large gaps <br>insufficient strength of the protective harness bifurcation, the lack of protection terminal harness <br>wiper arm shower pipe plug forceful enough tightening position, the loose plug , Leaking when spraying. <br>The profile light and the harness are not lit after they are inserted into place. The light is turned on when the harness is pushed hard, and it goes out when you let go. The preliminary analysis is that the lamp is not in proper contact with the harness terminal. <br>When the door control switch is sub-assembled, all four mounting holes are not snapped into the nut. The impact force of the pneumatic tool is strong, resulting in deformation of the nut seat.

仪表台骨架卡扣固定点位置偏低，卡固后与仪表台本体间隙大<br>线束分叉处防护强度不足，线束端子缺少防护<br>雨刮臂喷淋水管插接位置缩紧力度不足，插接后松动，喷淋时漏水。<br>示廓灯与线束插接到位后不亮，用力推动线束后灯亮，松手后熄灭。初步分析为灯与线束端子接触不实。<br>车门控制开关分装时未将四个安装孔全部卡入螺母，气动工具冲击力强，导致螺母座变形。

The fixed point of the instrument panel framework clasp is on the low side, and the gap between the clasp and the instrument panel body is large<br>The strength of protection at the branch of harness is insufficient, and the terminal of harness is lack of protection<br>The tightening force of the spray water pipe of the wiper arm is insufficient. It is loose after plugging, and water leaks during spraying.<br>After the clearance lamp and harness are inserted in place, they do not light up. Push the harness hard and the lamp will light up, and then it will go out. The preliminary analysis shows that the contact between the lamp and the harness terminal is not true.<br>When the door control switch is assembled separately, the four mounting holes are not all clamped into the nuts. The impact force of the pneumatic tools is strong, resulting in the deformation of the nut seat.<br>