非常感谢你时刻关注现场情况。对于H280链条与V280罐体底板接触的问

Thank you very much for keeping an eye on the scene. <br>Regarding the contact between the H280 chain and the V280 tank bottom plate. The opinion we discussed is that the main V280 tank bottom plate is caused by a bulge in the middle, and there is no problem with the side level of the bottom plate. However, it was originally proposed that the method of jacking up the V280 tank is not feasible, which may cause local deformation of the side plate of the V280 tank and cause greater damage to the equipment. First, squeeze the middle part after the V280 is filled with water, and the middle part is flattened downward. Secondly, check whether this can make it flat. If not, the second option is to increase the height of the two guide rails by 2mm under the H280 scraper. Do you think this is feasible?

Thank you very much for keeping an eye on the situation.<br>For the H280 chain contact with the V280 tank bottom plate. The view we discussed was that the central bulge of the main V280 tank base plate was caused and that there was no problem with the side level of the bottom plate. The original proposed V280 tank method is not possible, may lead to the V280 tank side plate local deformation, damage to the equipment is greater. First squeeze the middle after the V280 is filled with water, and the middle is when things level down. Second, check to see if this levels it. If not, the second option, under the H280 scraper, the two rail flat irons increase by 2mm. Do you think this is feasible?

Thank you very much for your attention to the situation on the spot.<br>For the problem of h280 chain contacting with the bottom plate of v280 tank body. The opinion we discussed is that the raised middle part of the main v280 tank bottom plate is caused by the raised side of the bottom plate, and there is no problem with the side level of the bottom plate. But the original method of lifting v280 tank is not feasible, which may cause the deformation of the side plate of v280 tank body, which will cause greater damage to the equipment. First, after v280 water injection, the middle part is squeezed, and the middle part is the matter going down and flattening. Second, check if this can make it flat. If not, the second scheme, the two guide rails under h280 scraper shall be increased by 2mm. Do you think it works?<br>