There is no problem with the delay in the answers, after all we have 13 hours of difference, so I imagine that at this time you are still sleeping. Below I answer your questions: The average depth of each drilling that has been made by neighboring mining deposits, which already have a confirmed gold reserve calculation is 800 meters on average. The Drill Tube they have used is Tricone Type. The area of each drilling rig is 150 square meters. The Sample Diameter varies between 47.6 and 54.7 millimeters. The Probing Diameter varies between 75.8 and 75.7 millimeters. I will appreciate present a proposal for the Initial Exploration of the geological fault where the mineralized body with Gold and Iron detected satellite runs, including the Cost of the diamond drilling equipment, the complementary equipment required such as compressors and required suction pumps, including a Tractor similar to type D6D and the Cost of Technical Assistance, under the modality of an EPC Type Contract. Important Note: The Regional Geology presents some tectonic faults with surface outcrops from the Jurassic to the Lower Tertiary, covered with volcanic rocks from the Miocene to Quaternary (Colluvial). The Geomorphology of the area presents Deposits with alluvial and colluvial material, small terraces and dry tributary streams. The Lithology presents fine-grained limestone Siltstones, Silty Sandstones, Carbonaceous limestones and Quartz sandstones.