在铝模早拆体系中，当墙柱混凝土强度达到1.2MPa，即可拆除侧模，一般

In the early dismantling system of aluminum molds, the side formwork can be removed when the concrete strength of the wall pillar reaches 1.2 MPa. In general, the concrete can be removed after 12 hours of pouring; when the beam and slab are removed, the strength reaches the design strength The top formwork can be removed after 50%. Generally, it can be removed after 48 hours, and the specific time will be determined after in-situ test blocks with the same conditions are tested. During the whole process, you can't dismantle it if you encounter a brace. The whole formwork system adopts quick dismantling method, so it is generally equipped with 4-6 layers of supporting struts, meteor hammers and other structural accessories. When the concrete strength of the component reaches 100% of the design strength, the support rod can be removed, and the same article left on site should be used before removal. <br>(2) The first floor formwork of the standard floor goes upstairs using the tower crane formwork, and the subsequent formwork can be transferred from the lower floor to the upper floor through the reserved material transfer port of the floor slab

In the aluminum mold early demolition system, when the concrete strength of the wall column reaches 1.2MPa, the side mold can be removed, in general, the concrete can be removed after 12 hours after pouring, the beam plate demolition when its concrete pouring strength reaches 50% of the design strength can be removed, in general, 48 hours after the demolition, the specific time according to the site to retain the same conditions after the test weight decision. Throughout the process, encountered there are support, can not be removed. The whole die system adopts the quick-removal method, so generally with 4-6 layers of prop-up pole, meteor hammer and other structural accessories. When the strength of the component crucible reaches 100% of the design strength, the support rod can be removed and the same bar should be retained on site before removal.<br>(2) Standard layer first floor template upstairs using tower hanging mold, the subsequent template can be passed from the lower layer to the upper level through the reserved material transfer port of the floor

In the early removal system of aluminum formwork, when the concrete strength of wall column reaches 1.2MPa, the side formwork can be removed, which can be removed 12 hours after the completion of concrete pouring in general; when the concrete strength of beam slab is 50% of the design strength after the completion of concrete pouring, the top formwork can be removed, which can be removed 48 hours later in general. The specific time shall be determined after the test block pressure test under the same conditions is retained on site Fixed. During the whole process, if there is support, it cannot be removed. The whole formwork support system adopts quick dismantling mode, so it is generally equipped with 4-6 layers of supporting pole, meteor hammer and other components. When the concrete strength of the component reaches 100% of the design strength, the support rod can be removed. Before the removal, the same article shall be retained on site.<br>(2) Tower crane is used to lift the formwork on the first floor of the standard floor, and the subsequent formwork can be transferred from the lower layer to the upper layer through the reserved material transfer port of the floor