支座是指用以支撑容器和设备的重量，并使其固定于一定位置的支撑部件，还要

The support refers to the supporting parts used to support the weight of the container and equipment and fix it in a certain position, but also bear the vibration and seismic load during operation. The structure of the support directly affects the working performance of the host. As far as the clamp device is concerned, the poor design of the support will affect the accuracy of the punching of the plate, so the design of the support is very important. The support supports the locking cylinder and the guide rail for normal work, and is connected to the base with threads, and moves with the rack and pinion drive to the main machine direction. First, analyze the structure of the support, combined with practical experience, the steel plate in the middle of the support should be welded At one third of the upper steel plate, the structure is shown in the following figure, where the thickness of the upper and lower welded steel plates is 12mm, and the thickness of the middle steel plate is 8mm.

支座是指用以支撑容器和设备的重量，并使其固定于一定位置的支撑部件，还要承受操作时的振动与地震载荷，支座的结构好坏直接影响到主机的工作性能，就夹钳装置而言，支座设计不好，会影响板材冲孔的精度，所以，支座的设计至关重要。本支座支撑锁紧缸和导轨进行正常工作，并且和底座用螺纹连接，随齿轮齿条传动一起向主机方向运动，首先分析支座的结构，结合实习经验，支座中间的钢板应分别焊接在上钢板三分之一处，其结构如下图所示，其中上下两焊接钢板的厚度是12mm，中间钢板的厚度是8mm，

The support refers to the support components used to support the weight of the container and equipment and make it fixed in a certain position, but also bear the vibration and earthquake load during operation. The structure of the support directly affects the working performance of the host machine. As for the clamp device, the poor design of the support will affect the accuracy of plate punching, so the design of the support is very important. This support supports the locking cylinder and guide rail for normal operation, and is connected with the base by screw thread. It moves to the main machine direction along with the transmission of gear teeth. First, analyze the structure of the support. Combined with practical experience, the steel plate in the middle of the support shall be welded at one third of the upper steel plate, and its structure is shown in the figure below, wherein the thickness of the upper and lower two welding steel plates is 12mm, and the thickness of the middle steel plate It's 8mm,<br>