前翻转盖板与角板面差超差原因1：前围缓冲胶墩未按图纸要求调整到位，导致

The front surface of the flip cover and the gusset difference tolerance <br>Reason 1: dash cushion gum fails pier drawings adjusted in place, resulting in the flip cover is closed gusset surface obvious difference <br>Cause 2: piers size plastic part comes with drawings Discrepancies <br>1. The component needle controls the size of the rubber pier and requires the supplier to paint the size of the rubber pier before leaving the factory. <br>2. The final assembly issues OK standards for the adjusted dimensions required by the drawings. <br>3. Move the rubber pier size to the production line before inspection. <br>Plan 1: Started on May 30th <br>Plan 2: Started on June 3rd <br>Plan 3: Started on June 10th and <br>has been supervised for 70 days without recurrence

The front flip cover is very different from the corner plate surface.<br>Reason 1: The front fence buffer gluon is not adjusted in place according to the requirements of the drawings, resulting in a significant difference with the angle plate after the flip cover is closed.<br>Reason 2: The component's own adhesive size does not match the drawing.<br>1, the component needle control glue to the size of the piece, and require the supplier to the factory to do paint marking on the size of the glue.<br>2, the total assembly for the drawing requirements of the adjustment of the size under the OK standard.<br>3, the size of the glue to the production line before the inspection.<br>Programme 1: Implementation commenced on 30 May.<br>Programme 2: Implementation commenced on 3 June.<br>Programme 3: Implementation commenced on 10 June.<br>No recurrence was supervised for 70 days.

The surface difference between the front turnover cover plate and the corner plate is out of tolerance<br>Reason 1: the front wall buffer rubber pier is not adjusted in place according to the drawing requirements, resulting in obvious difference between the overturned cover plate and the corner plate surface after closing<br>Reason 2: the dimension of the rubber pier attached to the parts does not conform to the drawing<br>1. The parts and components shall control the dimension of the rubber pier, and require the supplier to mark the dimension of the rubber pier with paint when leaving the factory.<br>2. General Assembly issues OK standard according to the adjustment size required by the drawing.<br>3. Move the dimension inspection of rubber pier to the production line.<br>Option 1: to be implemented on 30 May<br>Programme 2: to be implemented on 3 June<br>Programme 3: to be implemented on 10 June<br>There was no recurrence after 70 days of supervision<br>