4.3.1.3 Position the vertical refer

4.3.1.3 Position the vertical reference scribe lines on the seatback angle reference bar parallel to the body gridlines on the layout drawing.4.3.2 F RONT S EAT — DRIVER P OSITION —Leg and foot positioning for any specified Accelerator Heel Point location.4.3.2.1 Holding the torso portion of the template in position as outlined in 4.3.1.1 to 4.3.1.3, position the heel pointof the template at the specified heel point location. This point on the layout is located on top of the heelpad or the depressed floor covering surface at the Y plane centerline of the accelerator pedal.4.3.2.2 Holding the heel point at the specified location, rotate the foot forward until the Ball of the Foot contacts theundepressed accelerator pedal without infringing upon the 87 degrees minimum foot angle.4.3.2.3 The undepressed accelerator pedal (point of contact with Ball of Foot) may be determined by locating theheel point as described previously and presetting and locking the foot angle to 87 degrees.4.3.2.4 Draw in the template outline and pivot centers.4.3.3 F RONT S EAT — DRIVER P OSITION —Leg and foot positioning for any specified undepressed accelerator pedallocation.4.3.3.1 Holding the torso portion of the template in position as outlined in 4.3.1.1 to 4.3.1.3, position the Ball of theFoot on the specified undepressed accelerator pedal with the sole of the foot on the pedal and the heel asfar forward as allowable. However, the foot angle is never less than 87 degrees. Lock foot angle quadrant.4.3.3.2 Draw in the template outline and pivot centers.4.3.4 F RONT S EAT — DRIVER P OSITION —Leg and foot positioning for any specified leg room and SgRP-front to heel.4.3.4.1 Holding the torso portion of the template in position, as outlined in 4.3.1.1 to 4.3.1.3, position the heel pointof the template at the specified height. SgRP-front to heel, and the foot angle locked at 87 degrees.