2) 检查和设置固件为确保您的交换机在安装后立即发挥最佳性能，建议您在

2) Checking and setting the firmware <br>To ensure that your switch performs at its best immediately after installation, it is recommended that you perform a firmware upgrade before installing the switch. <br> Plug the switch into power and connect to the wired Internet. <br> After the switch is powered on, the power LED will be solid orange. <br> If the device needs to be upgraded, the power LED will start blinking white until the upgrade is complete, at which point the LED will turn solid white. Depending on the speed of your current Internet connection, you should wait at least a few minutes for the firmware upgrade to complete. <br>3) Assigning IP Addresses <br>All switches must be assigned routable IP addresses. These IP addresses can be assigned dynamically or statically via DHCP. <br>4) Use DHCP to assign management addresses <br>When using DHCP, you need to configure the DHCP server to assign a static IP address to each MAC address of the Meraki switch. Other functions of the network, such as 802.1X authentication, may rely on the switch's ability to have a static IP address.

2) Check and set firmware<br>To ensure the best performance of your switch immediately after installation, it is recommended that you upgrade the firmware before installing the switch.<br> connect the switch to the power supply and connect with the wired internet.<br> after the switch is powered on, the power LED will be orange and always on.<br> if the equipment needs to be upgraded, the power LED will start flashing white until the upgrade is completed, and then the LED will become normally bright white. Depending on the current Internet connection speed, you should wait at least a few minutes to complete the firmware upgrade.<br>3) Assign IP address<br>All switches must be assigned routable IP addresses. These IP addresses can be allocated dynamically or statically through DHCP.<br>4) Assign management addresses using DHCP<br>When using DHCP, you need to configure the DHCP server to assign a static IP address to each MAC address of the Meraki switch. Other functions of the network, such as 802.1x authentication, may depend on the static IP address characteristics of the switch.

2) Check and set the firmware. To ensure the best performance of your switch immediately after installation, it is recommended that you upgrade the firmware before installing the switch. Connect the switch to the power supply and connect it to the wired Internet. When the switch is powered on, the power LED will be on in orange. If the equipment needs to be upgraded, the power LED will start flashing white until the upgrade is completed, at which time the LED will turn to solid white. You should wait at least a few minutes to complete the firmware upgrade, depending on the current Internet connection speed. 3) Assign IP address All switches must be assigned routable IP addresses. These IP addresses can be allocated dynamically or statically by DHCP. 4) Use DHCP to assign the management address When using DHCP, you need to configure DHCP server to assign a static IP address to each MAC address of Meraki switch. Other functions of the network, such as 802.1X authentication, may depend on the switch having a static IP address.