Ok, this method will deal with the HCl salt of pfed, and a streamlined version of "the cure"!All pills are dumped into a large jar and double the volume of methanol poured on top!This is stirred vigorously and let to settle, in the fridge seems to speed it up!After top methanol layer has cleared it is carefully decanted off.This procedure is repeated 3 times.All methanol pulls are put together and reduced on a hot plate.As methanol gets down to last little bit, it is taken off heatThen a portion of acetone, twice your remaining liquid is dropped in.This forces the pfed crystals to crash out.Then remaining liquid is carefully eared off.Now you have your crude/dirty pfed HCl.Next we will be doing successive toluene washesSo put your pfed crystals in a pyrex (heat proof glass)Now add toluene to a safe level that can be lightly boiled on hot plateAfter about 5 mins boiling with stirring.Take off heat and let settle a minute.Now carefully pour off toluene into a filter to catch any remnants of pfed that may follow.Now if you get the toluene that has our contaminants in it and add some waterYou will see the crap crash from the toluene into the waterThis is the crap that came thru with the methanol pull!So as we continue to do multiple toluene washes,We will continue to test the toluene after pouring it off,To see how we are progressing with the cleanup!When we have reached a point where no crap comes out of the toluene,With the addition of water, then we are ready to try acetone!Usually about 3 boils in toluene, but of course it depends how much your using!So, as before we will add a portion of acetone and boil lightly!Now when we pour off the acetone, we will add a tiny amount of water and some NaOHThis is our final test, when you do this and no crap falls out of acetone you are ready!This will be the cleanest pfed you have ever seen, guaranteed!AND, yields should be >90% if your careful! 95% is good