如图3所示,在0.25MPa下,污泥最终含水率的下降是由于添加了不同的添加剂导致的。而对于单一的添加剂,其含水率下降随压力的增加,大约都下降的英语翻译

如图3所示,在0.25MPa下,污泥最终含水率的下降是由于添加了不同的

如图3所示,在0.25MPa下,污泥最终含水率的下降是由于添加了不同的添加剂导致的。而对于单一的添加剂,其含水率下降随压力的增加,大约都下降2~3%。这是由于压力增加的原因,并不是因为使用了不同的添加剂,是不是可以认为在添加过添加剂之后含水率的下降就和添加剂无关了,而是和压力相关。那么文章中所说的含水率下降的9%是不是就不全是添加添加剂的原因?
0/5000
源语言: -
目标语言: -
结果 (英语) 1: [复制]
复制成功!
As shown in FIG. 3, at 0.25MPa, decrease the final moisture content of sludge is the addition of different additives caused. For a single additive, which increases with water content decreased pressure has fallen to about 2-3%. This is the reason due to the pressure increase, not because of the use of different additives, is not considered to be in decline after adding the additives had on the moisture content of additives and nothing to do, but and stress-related. So the article said moisture content of 9% decline is not a reason not all additives are added?
正在翻译中..
结果 (英语) 2:[复制]
复制成功!
As shown in Figure 3, at 0.25MPa, the decrease in the final moisture content of the sludge is due to the addition of different additives. For a single additive, its water content decreases with the increase of pressure, and it decreases by about 2 to 3%. This is due to increased pressure, not because of the use of different additives, is it possible to think that after the addition of additives, the decline in moisture content is not related to the additive, but is related to pressure. So the article said that the water content of 9% decline is not all the reason for adding additives?
正在翻译中..
结果 (英语) 3:[复制]
复制成功!
As shown in Fig. 3, at 0.25MPa, the decrease of final water content of sludge is caused by the addition of different additives. For a single additive, the water content decreases about 2-3% with the increase of pressure. This is because of the increase of pressure, not because of the use of different additives, is it possible to think that the decrease of water content after adding additives has nothing to do with additives, but with pressure. So is the 9% decrease of water content mentioned in the article not all the reason for adding additives?
正在翻译中..
 
其它语言
本翻译工具支持: 世界语, 丹麦语, 乌克兰语, 乌兹别克语, 乌尔都语, 亚美尼亚语, 伊博语, 俄语, 保加利亚语, 信德语, 修纳语, 僧伽罗语, 克林贡语, 克罗地亚语, 冰岛语, 加利西亚语, 加泰罗尼亚语, 匈牙利语, 南非祖鲁语, 南非科萨语, 卡纳达语, 卢旺达语, 卢森堡语, 印地语, 印尼巽他语, 印尼爪哇语, 印尼语, 古吉拉特语, 吉尔吉斯语, 哈萨克语, 土库曼语, 土耳其语, 塔吉克语, 塞尔维亚语, 塞索托语, 夏威夷语, 奥利亚语, 威尔士语, 孟加拉语, 宿务语, 尼泊尔语, 巴斯克语, 布尔语(南非荷兰语), 希伯来语, 希腊语, 库尔德语, 弗里西语, 德语, 意大利语, 意第绪语, 拉丁语, 拉脱维亚语, 挪威语, 捷克语, 斯洛伐克语, 斯洛文尼亚语, 斯瓦希里语, 旁遮普语, 日语, 普什图语, 格鲁吉亚语, 毛利语, 法语, 波兰语, 波斯尼亚语, 波斯语, 泰卢固语, 泰米尔语, 泰语, 海地克里奥尔语, 爱尔兰语, 爱沙尼亚语, 瑞典语, 白俄罗斯语, 科西嘉语, 立陶宛语, 简体中文, 索马里语, 繁体中文, 约鲁巴语, 维吾尔语, 缅甸语, 罗马尼亚语, 老挝语, 自动识别, 芬兰语, 苏格兰盖尔语, 苗语, 英语, 荷兰语, 菲律宾语, 萨摩亚语, 葡萄牙语, 蒙古语, 西班牙语, 豪萨语, 越南语, 阿塞拜疆语, 阿姆哈拉语, 阿尔巴尼亚语, 阿拉伯语, 鞑靼语, 韩语, 马其顿语, 马尔加什语, 马拉地语, 马拉雅拉姆语, 马来语, 马耳他语, 高棉语, 齐切瓦语, 等语言的翻译.

Copyright ©2024 I Love Translation. All reserved.

E-mail: