对不起，由于小职家中有事，客户验货当天小职休息。 小职分析具体原因以

对不起，由于小职家中有事，客户验货当天小职休息。 <br> <br>小职分析具体原因以下几点： <br>1，温度没有达到设定温度（80°），温度较低，机头压力大，导致溢胶。 <br>2，橡胶胶条切块较大，导致喂料量偏高，产生机头压力较高，导致溢胶。 <br>3，机头口型在没有出胶状态下，有可能挤出机转速超出（初始转速5rpm），导致溢胶。

Sorry, the customer has a rest on the day of inspection due to something at home.<br>The specific reasons for the analysis of minor positions are as follows:<br>1. The temperature did not reach the set temperature (80 °), the temperature was low and the head pressure was high, resulting in glue overflow.<br>2. The rubber strip is cut into large pieces, resulting in high feeding volume and high head pressure, resulting in glue overflow.<br>3. When there is no glue out of the die, the extruder speed may exceed (initial speed 5rpm), resulting in glue overflow.

I'm sorry, due to something at home, the employee will have a rest on the day of customer inspection. Small job analysis specific reasons are as follows: 1. The temperature did not reach the set temperature (80), the temperature was low, and the head pressure was high, resulting in glue overflow. 2. The rubber strip is cut into large pieces, which leads to high feeding rate and high head pressure, which leads to rubber overflow. 3. If there is no glue discharge at the die, it is possible that the speed of the extruder exceeds (the initial speed is 5rpm), resulting in glue overflow.