采用2.0mm厚钢板焊接而成，表面喷塑。正面开门处开两个手工操作孔。为

It is welded by 2.0mm thick steel plate, and the surface is sprayed with plastic. Two manual operation holes are opened at the front door opening. In order to reduce the accumulation of finer sand on the screen of the hopper plate, the main body and the sand collecting hopper on both sides adopt stainless steel wire mesh with a hole width of 5mm to facilitate sand leakage, and the wire mesh and the hopper plate are connected by a movable connection for easy maintenance. <br>No insulating coating can be applied inside the sandblasting host.

Welded with 2.0mm thick steel plate, the surface is spray-molded. Open two hand-operated holes at the front door. In order to reduce the accumulation of fine sand on the body plate screen, the host and both sides of the sand hopper filter are using a hole width of 5mm stainless steel screen to facilitate sand leakage, wire mesh and bucket board with active connection for easy access.<br>The inside of the blasting host is not coated with insulation.

It is welded with 2.0 mm thick steel plate and sprayed with plastic on the surface. Two manual operation holes are opened at the front door opening. In order to reduce the accumulation of fine sand on the screen on the bucket plate, stainless steel wire mesh with a hole width of 5mm is used for filtering of the main engine and sand collecting hopper on both sides to facilitate sand leakage. The movable connection between the steel wire mesh and the bucket plate is convenient for maintenance.<br>No insulating coating can be applied inside the sandblasting host.