Missing dust plug cover for rear axle brake drum <br>Dynamic interference between the medium-bridge ventilation and reed <br>Air compressor feedback trachea less fixed <br>Air-storage tube lack guide fixed bracket <br>Air compressor outlet pipe and transmission harness interference <br>Fuel fine filter harness and tube bundle holder ribedge interference <br>Interference with screw head in the inside harness of the right vertical beam <br>Interference between the fuel pipe and the heating pump support <br>Uneven gaps between the wing and the body <br>The gauge mask is not in place <br>Front license plate mounting plate rust <br>Front perimeter large line box cover plate off <br>Floor skin spout not in place <br>The decorative plate of the deputy instrument stand is not installed <br>High-level intake trachea sleeve not installed in place <br>Right front gearstop bracket rust <br>Sub-start identification edge <br>Urea box fixing bracket rust <br>Dryer harness is not secured properly <br>High-level intake pipe fixing screw loose <br>Dynamic interference between the sub-water tank out of the water hose and the in-cooler inlet clamp screw <br>Small gap between the rear suspension retaining pipe and the exhaust pipe (30mm) <br>Damage to engine ECU harness chuck shell <br>Damage at the fixed point of the engine soundproof ingenum <br>Brake total pump trachea and fender interference <br>The front windscreen does not fit along the strip <br>The profile lamp assembly is not correct <br>Raise-up cylinder oil pipe and warm-air pipe bracket edge interference <br>The right end of the front mask doesn't get stuck. <br>Left door inside scratch <br>Uneven gaps between the left door interior panel and the speaker cover <br>Inconsistent assembly status of overhead plug <br>Travel recorder fixed pine <br>The sun visor is rough <br>The protective plate inside the roof is not in place <br>Large gap between the roof inner guard and the side inner shield <br>Interior panels dirty <br>Middle panel scratch <br>Sunvisor folds, uneven <br>Soot box holder does not return to position
正在翻译中..