现在已经查明有1000个错误参数的MCU被用到这两批货中现在可以确定芯

It has been found that the MCU with 1000 wrong parameters was used in these two batches. <br><br>Now it can be determined that there is no problem with the chip. The problem is: the clock parameter of the single-chip microcomputer is wrong, because at that time one of the burners needed to re-input the software due to failure In addition to the clock parameters, the technician may have forgotten to change the default clock frequency parameters in a certain setting, which caused the operating clock of this batch of single-chip microcomputers to be twice as fast as expected, so that the 8-hour timing became 4 hours, and it could not be verified. The accident affected the 9.02 shipping schedule and 9.21 batches. There may be about 800 problematic tubes in total. The subsequent orders are not affected. <br><br>Some of the MCU clock parameters are incorrect

MCUs with 1,000 error parameters have now been identified as being used in both shipments<br><br>Now you can determine that the chip is no problem, the problem is: the clock parameters of the microcontrol is wrong, because one of the burners due to failure needs to re-enter the software and clock parameters, the technician may have forgotten to change the default clock frequency parameters in a certain setting, resulting in the batch of microcontrol clock than expected, so that 8 hours of timed into 4 hours, and could not be tested out. The accident affected 9.02 ships and 9.21 batches, and the total number of pipes in question could be about 800. Those following orders are not affected.<br><br>Some of the number of syn clock parameters are incorrect

Now it has been found that the MCU with 1000 wrong parameters has been used in these two batches<br>Now it can be determined that there is no problem with the chip. The problem is: the clock parameters of the single-chip microcomputer are wrong, because one of the burners needs to re-enter the software and clock parameters due to a fault. The technician may forget to change the default clock frequency parameter in a certain setting. As a result, the operating clock of the batch of single-chip computers is twice as fast as expected, so that the 8-hour timing becomes 4-hour, and can not be checked Check it out. The accident affected the 9.02 shipping date and 9.21 batches, and there may be about 800 defective pipes. Subsequent orders have not been affected.<br>Some of the clock parameters of single chip microcomputer are wrong<br>