在砌块砌筑时应采用先铺砂浆后压砖校正的方式进行，根据灰缝厚度要求用灰铲

When building blocks, the mortar should be laid first and then the bricks should be corrected. The mortar should be spread with a ash shovel according to the thickness of the mortar joint. The length of the mortar should meet the relevant technical specifications. Then align the block with the masonry line and lay it aside steadily, squeeze it, and hammer it with a wooden or rubber hammer until it is tightly combined with the mortar. It is required to build and correct a block during the masonry process to minimize the number of rework.

In masonry masonry should be done by first laying mortar and then pressing brick correction, according to the requirements of gray seam thickness with a gray shovel to spread the mortar, the length of the plaster should comply with the relevant technical specifications. Then align the block to the masonry line smoothly shelved, squeeze, and hit with a wooden hammer or rubber hammer until tightly combined with the mortar, requiring the masonry process to build a piece, correction of a piece, to minimize the number of reworks.

When building blocks, the mortar shall be paved first and then the brick shall be pressed for correction. According to the thickness of mortar joint, the mortar shall be paved with mortar shovel, and the length of mortar paving shall comply with relevant technical specifications. Then, the blocks shall be placed in line with the masonry line, extruded and hammered with wood hammer or rubber hammer until they are closely combined with the mortar. It is required to build and correct one block in the masonry process, so as to reduce the rework times as much as possible.<br>