Below images are copy from MLL, QC report dated 1/6/2020, 8/17/2019, 5/9/2019, 11/7/2018Peter measured sample in BNK today – 7.44” x 7.2” x 0.59” (including plastic cap on feet) = 189 x 182.8 x 15 (do not match MLL), sample date is 5/21/2018, pre-shipment sample. The sample in BNK is very close to the dimension in MLL, acceptable variance. This is a sand casted item, variance would be bigger than die-cast, variance shown on QC reports, has few mm variance are all OK, but I am surprised to see that the “Item Spec” on QC report varies from 1 to another, why? Should the data be extracted from MLL (It does not match MLL)? Where did QC get the “Item Spec”?