Fender与驾驶室间隙不均保险杠上装饰板与翻转轴存在干涉工具箱盖板开

Fender cab uneven gaps <br>interference exists trim panel to the bumper and the reverse shaft <br>toolbox cover open and the interference body side <br>opening and the handbrake sheath interference sleeper kit <br>enclosed within the shield after pasting inaccurate <br>battery cover deformation <br>before Mask lacquer unevenness <br>Fuel tank bracket cracks <br>Exhaust pipe surface pull marks <br>Sleeper lower toolbox bracket Welding slag <br>platform air outlet adjustment failure (wind panel closed)

Fender and cab clearance uneven<br>Interference between the decorative plate and the flip shaft on the bumper<br>Toolbox cover opening and body side-by-side interference<br>Sleeper under-toolbox open with handbrake shell interference<br>The back inner guard is not pasted<br>Battery case cover deformation<br>The front mask is painted uneven<br>Fuel tank carrier crack<br>Exhaust pipe surface pull marks<br>Sleeper under toolbox bracket slag<br>Medium platform air outlet adjustment fault (wind control plate off)

The gap between fender and cab is uneven<br>There is interference between the upper bumper trim panel and the turning shaft<br>The opening of the tool box cover plate interferes with the body side wall<br>The opening of the tool box under the sleeper interferes with the handbrake housing<br>The back wall inner guard board is not pasted firmly<br>Battery box cover deformed<br>Uneven paint edge of front cover<br>Crack in fuel tank bracket<br>Pull mark on exhaust pipe surface<br>Welding slag of tool box support under sleeper<br>Air outlet adjustment failure of middle platform (air regulator closed)<br>