1、此问题是由于发热板接片生产时在进行冲压工艺后表面会存在少许的冲压油

1. This problem is due to the fact that there is a little stamping oil on the surface after the stamping process during the production of the heating plate tabs, and then some small impurities will stick to the tabs when assembling the heating plate; these impurities, stamping oil stains are just assembled in the product When energized, a small spark will be generated. After one or several dry-burning cycles, the impurities and oil stains on the tabs will be evaporated, and this bad phenomenon will not occur.

1, this problem is due to the heating plate patch production in the stamping process after the surface will exist a little stamping oil, the subsequent assembly of the heating plate will stick some small impurities on the patch;

1. This problem is due to the existence of a small amount of stamping oil on the surface of the heating plate after the stamping process during the production of the heating plate, and some small impurities will be stuck on the connecting piece during the subsequent assembly of the heating plate; these impurities will produce small sparks when the product is just assembled, and the impurities and oil stains on the connector will be evaporated after one or several dry burning cycles, This will not happen.<br>