“调整校正挡”按钮，在跳出界面中点击“输入校正值”按钮，然后点击“试刻

"Adjust calibration block" button, click the "input calibration value" button in the pop-up interface, and then click "test engraving", the galvanometer will start to engrave a 33*33 cross on the material, click the "return" button after the marking is completed, and click In the option interface, select the calibration document in the lens manager and close the interface, as shown in Figure 2-12, exit the Markingmate software.

"Adjust correction stop" button, click on the "Enter correction positive value" button in the jump out of the interface, then click on the "trial engraving", the mirror began to carve 33 x 33 cross on the material, after marking the completion of the click on the "back" button, and in the option interface lens administrator selected to correct the document after closing the interface, as shown in Figure 2-12, exit the Markingmate software.

Click "input correction value" button in the pop-up interface, and then click "trial engraving". The galvanometer begins to carve 33 * 33 cross on the material. After marking, click the "return" button, and select the correction document in the option interface lens administrator to close the interface. As shown in Figure 2-12, exit the markingmate software.<BR>