由于机架是用来安装减速机的，所以其尺寸应与减速机的尺寸相匹配。本设计采

Since the frame is used to install the reducer, its size should match the size of the reducer. This design uses a single fulcrum frame, which can use the bearing on the output shaft side of the reducer as the fulcrum, or the intermediate bearing can be set in the mixing container as the fulcrum. Because the diameter of the mixing shaft of this design is 100mm, according to reference [1] P313, the rack with a nominal diameter of 500mm is selected, the model is b500-100, and the material is HT200.

由于机架是用来安装减速机的，所以其尺寸应与减速机的尺寸相匹配。本设计采用单支点框架，可将减速器输出轴侧的轴承作为支点，也可将中间轴承设置在搅拌容器中，作为支点。由于本设计搅拌轴直径为100mm，根据文献[1]P313查阅，选用公称直径为500mm的机架，型号为b500-100，材质为HT200。

Since the rack is used to install the reducer, its size should match the size of the reducer. In this design, the bearing on the output shaft side of the reducer can be used as the fulcrum, or the intermediate bearing can be set in the mixing vessel as the fulcrum. As the diameter of the mixing shaft in this design is 100mm, according to the reference [1] P313, a frame with a nominal diameter of 500mm is selected, the model is b500-100, and the material is HT200.<br>