4. 瓶身除水机（干燥机） 设计要求：利用离心式鼓风机提供必要的空气

4. Bottle dewatering machine (dryer) <br> Design requirements: Use a centrifugal blower to provide the necessary air volume and speed to remove water from the container and lid. Wind removes excess moisture from under the cover <br> Installation requirements: All necessary installation components, including nozzle support brackets and legs should be adjustable; <br> Assemble the shell to prevent spraying <br> Inlet filter/silencer (0.5 micron or more Good) Only the filter can be replaced <br>. The housing of the wind knife should be made of stainless steel. The enclosure should be provided for easy cleaning. The <br>air knife drying system must not use compressed air in any position. <br> Frequency conversion drive <br> Manual buttons (emergency stop, start, stop) are required on the operator control panel <br> Type change requirement: one-key switch <br> Sealing requirement: good sealing type, no water splashing to the outside of the equipment <br> Water accumulation: special base Designed to collect and discharge effusion to prevent water accumulation <br> Safety requirements: refer to the safety requirements of aseptic filling machines

4. Bottle body dewaterer (dryer)<br>Design requirements: Use centrifugal blowers to provide the necessary air volume and speed to remove water from containers and lids. The wind removes excess moisture from under the lid.<br>Installation requirements: All necessary mounting components, including nozzle support brackets and legs, should be adjustable;<br>Assemble the housing to prevent spraying.<br>The inlet filter/silencer (0.5 microns or better) can only replace the filter.<br>The wind knife housing should be made of stainless steel. The housing should be provided for easy cleaning.<br>The air knife drying system must not use compressed air in any position.<br>Variable frequency drive.<br>Manual buttons are required on the operator control panel (emergency stop, start, stop)<br>Change requirements: one-click switch.<br>Sealing requirements: Good sealing type, no water splashed on the outside of the equipment.<br>Anti-accumulation water: The base is specially designed to collect drains and prevent the generation of water.<br>Safety requirements: Refer to the safety requirements of sterile filling machines.

4. Bottle body dehydrator (dryer)<br>Design requirements: centrifugal blower shall be used to provide necessary air volume and speed to remove water from containers and covers. The wind removes excess moisture from under the cover<br>Installation requirements: all necessary installation components, including nozzle support bracket and outrigger, shall be adjustable;<br>Assemble the shell to prevent spraying<br>Inlet filter / muffler (0.5 μ m or better) can only replace the filter<br>The air knife shell shall be made of stainless steel. The enclosure shall be provided for easy cleaning<br>The air knife drying system shall not use compressed air at any position.<br>Frequency conversion drive<br>Manual buttons (emergency stop, start, stop) are required on the operator control panel<br>Switch requirements: one key switch<br>Sealing requirements: good sealing type, no water splashing to the outside of the equipment<br>Prevention of ponding: the base is specially designed to collect and discharge liquid and prevent water accumulation<br>Safety requirements: refer to the safety requirements of aseptic filling machine<br>