副驾驶员左下裙板滑槽无法装配到位中长车身普通地板车型副驾驶员坐在左下裙

The co-driver's lower left apron chute cannot be assembled in place <br>. Medium and long body normal floor models. The co-driver sits on the left lower apron. The fixed chute cannot be installed in place. <br>1. There is a step at the overlap between the middle floor of the white body and the right floor, and the middle floor is higher. The right side panel <br>2. The overlap edge of the middle floor and the friend floor is close to the chute installation hole <br>3. The chute installation structure is a compression structure of rotary clamping, which is affected by the middle floor step and cannot be properly and tightly attached to the right floor. . <br>1. It affects the installation of the skirt chute, and it will fall off after barely installation, which will affect the completion of thousands of units and AUDIT; <br>2. Once it falls off, it will affect the sealing of the whole vehicle and cause dust to enter. It is <br>recommended to design and optimize the installation structure of the skirt chute, which is connected by rotating clamps. Changed to insert card connection structure

The co-pilot's lower left skirt chute cannot be fitted in place<br>The co-pilot of the medium-length body ordinary floor model sits on the lower left apron fixing chute and cannot be installed in place<br>1, the white body of the middle floor and the right floor at the end of the existence of steps, the middle floor higher than the right plate<br>2, the middle floor and the friend floor mating edge distance chute installation hole distance<br>3, chute installation structure for the rotation of the clamping structure, affected by the mid-floor steps, can not fit closely on the right floor.<br>1, affecting the installation of skirt chute, reluctantly installed after easy to fall off the impact of thousands of units and AUDIT completion;<br>2, once the shedding affects the sealing of the whole vehicle, resulting in ash<br>It is recommended to design and optimize the mounting structure of the skirt slip slot, which is changed from a rotating card to an inserted card structure

Front passenger left lower apron chute cannot be assembled in place<br>The co driver of medium and long car with common floor can not be installed in place when sitting in the fixed chute of the left lower apron<br>1. There are steps at the lap joint between the middle floor and the right floor of BIW, and the middle floor is higher than the right floor<br>2. The lap edge of the middle floor and the friendly floor is close to the installation hole of the chute<br>3. The installation structure of the chute is a compression structure of rotary clamping, which can not fit on the right floor due to the influence of the middle floor steps.<br>1. Affect the skirt chute installation, easy to fall off after forced installation, affect the completion of 1000 sets and audit;<br>2. In case of falling off, the sealing of the whole vehicle will be affected, resulting in ash feeding<br>It is suggested to design and optimize the installation structure of the apron chute, and change the rotating clamping structure into the inserting clamping structure<br>