Harvesting operation skills:During the harvesting operation, there may be the phenomenon of the harvest is not smooth or not orderly, according to the following operation method: start the harvester strap slant on the left shoulder, the harvester is placed on the right side, the operator naturally stand straight, the two hands of the natural end of the hand handle, so that the blade and the ground to maintain a parallel state, the blade from the ground 3-4 cm. Keep the gas pedal on 1/2 or 1/3 of the way. After the blade runs smoothly, feed in the front end of the grain collector at the curved hook position, swing from the right side in a straight line to the left, the speed can not be too slow, uniform force, can not stop in the middle, otherwise the grain collector will tangle into the straw. Stubble should not be too high, the cutting width should be moderate, do not cut too wide, too thick, otherwise affect the harvest effect, it is difficult to pile up neatly.Note: in case of sudden vibration of the blade during harvesting operation, the machine should be shut down immediately, and the blade should be pressed to the ground to stop the machine. Check whether the blade has cracks, gaps and distortions, and stop using it immediately. If the blade is loose, tighten the left-hand nut. If the blade is entangled in straw, the machine should be shut down immediately, and then remove weeds.Warning: During operation, the operator should be the center, and no one should be standing within the radius of 15m.