1、储物箱右侧挡板背面缺少支撑2、零部件塑料挡板变形仪表台副驾驶处骨架

1. The back of the right side baffle of the storage box lacks support. <br>2. The plastic baffle of the parts is deformed <br>. The frame card joint at the co-pilot of the instrument panel is low. After the clamping, the gap between the instrument panel and the body of the instrument panel is large <br>. The <br>plugging position of the spray pipe of the protective wiper arm is insufficiently tightened, loosened after plugging, and leaked during spraying. <br>The profile light and the harness are not lit after they are inserted into place. The light is turned on when the harness is pushed hard, and it goes out when you let go. The preliminary analysis is that the lamp is not in proper contact with the harness terminal. <br>When the door control switch is sub-assembled, all four mounting holes are not snapped into the nut. The impact force of the pneumatic tool is strong, resulting in deformation of the nut seat.

1, the storage box right side of the back of the bezel lack of support<br>2, parts of plastic bezel deformation<br>The skeleton card connection at the vice-driver of the instrument station is low, and the gap between the gauge table body is large after the card is secured.<br>Insufficient protection at the harness branch, lack of protection at the harness terminals<br>Wiper arm spray water pipe insertion position tension is insufficient, after insertion loose, spray water leakage.<br>The profile light and the harness are not lit when plugged into the position, push the rear light of the harness to light, and turn off after loosening your hand. The preliminary analysis indicates that the contact between the lamp and the harness terminal is not true.<br>The door control switch was not divided into the nut all four mounting holes, the pneumatic tool impact force is strong, resulting in the nut seat deformation.

1. Lack of support on the back of the right side baffle of the storage box<br>2. Parts plastic baffle deformed<br>The frame of the front passenger's seat of the instrument panel is on the low side, and the gap between the frame and the instrument panel body is large after being clamped<br>The protection strength at the branch of harness is insufficient, and the harness terminal is lack of protection<br>The tightening force of the spray water pipe of the wiper arm is insufficient. It is loose after plugging, and water leaks during spraying.<br>After the clearance lamp and harness are inserted in place, they do not light up. Push the harness hard and the lamp will light up, and then it will go out. The preliminary analysis shows that the contact between the lamp and the harness terminal is not true.<br>When the door control switch is assembled separately, the four mounting holes are not all clamped into the nuts. The impact force of the pneumatic tools is strong, resulting in the deformation of the nut seat.