雨刮臂喷淋水管插接位置缩紧力度不足，安装后松动，存在时漏水。示廓灯与线

The connecting position of the spray pipe of the wiper arm is not tightened enough, and it is loose after installation, and leaks when it exists. <br>The profile light and the harness are not lit after they are inserted into place. The light is turned on when the harness is pushed hard, and it goes out when you let go. The preliminary analysis is that the lamp is not in proper contact with the harness terminal. <br>When the door control switch is sub-assembled, all four mounting holes are not snapped into the nut. The impact force of the pneumatic tool is strong, resulting in deformation of the nut seat.

Wiper arm spray water pipe insertion position tension is insufficient, loose after installation, leakage when there is.<br>The profile light and the harness are not lit when plugged into the position, push the rear light of the harness to light, and turn off after loosening your hand. The preliminary analysis indicates that the contact between the lamp and the harness terminal is not true.<br>The door control switch was not divided into the nut all four mounting holes, the pneumatic tool impact force is strong, resulting in the nut seat deformation.

The plug-in position of the spray water pipe of the wiper arm is not tight enough, and it is loose after installation, and there is water leakage.<br>After the clearance lamp and harness are inserted in place, they do not light up. Push the harness hard and the lamp will light up, and then it will go out. The preliminary analysis shows that the contact between the lamp and the harness terminal is not true.<br>When the door control switch is assembled separately, the four mounting holes are not all clamped into the nuts. The impact force of the pneumatic tools is strong, resulting in the deformation of the nut seat.<br>